Step By Step Roof Installation

Eave trim also referred to as drip edge is the first piece of trim that will be installed on your metal roof.

Step by step roof installation. Never step on any of the ladder rungs above the roof. Step by step roll roofing installation. There are three systems including glue down torch. Trim the shingles away from the ridge vent hole.

Attach the plastic ridge vent with 3 roofing nails. For hip and ridge capping specialized shingle accessories may be used that have their own set of manufacturer s instructions. Roll roofing is made from the same asphalt composition material as shingles and it s easier to install. This step by step installation article specifically covers eave trim installation for an exposed fastener panel such as.

Rent tools and trucks for any project at the home depot. If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof. The final step in the roof installation process is to conclude with hip and ridge shingle application. Set up scaffolding to install the drip edge and first few courses.

Don t worry if you don t own all of the tools needed to complete this diy project. For a sturdy foundation roof mount flashings should be bolted to your roof rafters. If you re installing an off grid system or a grid tie system with a battery backup the last step of installation for your system will be to install a battery bank. Position the ridge cap shingles over the ridge vent.

Attach he ridge cap shingles with two nails each. This guide will teach you about metal roof types and give you step by step instructions on how to install a metal roof. There are three types of batteries used in solar storage.