Troubleshoot Door Lock Strike Wont Slide

You will need to simply take the lock off the door.

Troubleshoot door lock strike wont slide. If you are operating the lock on ac instead of dc or on half wave rectified dc transformer single diode the lock won t hold. It did not latch shut. Close the door and test the fit. Try to open the door while it is shut.

For some door locks you might need to file off sections of the strike plate for it to fit properly. Slide the door strike in the opening making sure the back of the strike slides into the small. Line up the back of the replacement door strike with the narrow opening in the body of the dishwasher. This gunk and grime can impede the movement of springs as well.

And if it still doesn t work it s probably time to go to the store to pickup a new doorknob. The thicker the cardboard the harder it may be to cut but it could save you from having to use several pieces while packing it out. In addition to cleaning and lubricating sliding door tracks you want to lubricate the door lock. The lock won t latch at all.

Step 3 place the cardboard. The best way to lubricate any lock is to disassemble it and use an aerosol lubricant to flush away grime and coat the moving parts of the lock. Adjustable strike plate not properly aligned. It needs to spring into the recess in the door strike to keep the door closed.

Troubleshooting a stuck door latch. From there try some lubricant silicone spray and graphite powder are my preferred lubricants for locks wd 40 will quickly dry and attract dirt. To correct the problem try loosening the strike mounting screw to see if the lock then holds properly. Apply a lubricant to both upper and lower tracks to keep the door hardware clean and operating freely.

See the article adjusting door strike plates for directions on how to fix a poorly aligned strike plate. Unscrew the strike plate and reposition it. This sliding glass door lock was not working. If the strike is mounted too rigidly proper alignment can t occur and the lock won t hold.

A door that is sagging may cause the door strike to hit the strike plate to low not allowing it to spring into place. Place the cardboard behind the strike plate. Ideally the bolt should rest flush within the strike plate. Door sagging out of square in frame uneven head margin.

The door is not meeting the weatherstrip evenly when it closes hitting the top or bottom first. Place the top screw in and tighten it slightly. Realign reshim readjust lockside jamb so door meets weatherstrip evenly from top to bottom. It s an easy fix.

Realign adjustable strike plate. You can unscrew the door knob and remove both sides then unscrew the latch and pull it out of the door. Donations appreciated click in upper right corner info circle.